Tektronix 5110, Инструкция по эксплуатации

Страница: 28 / 128

Specification and Performance Check-5110
Table 2-9 (cont)
LIST OF TEST EQUIPMENT REQUIREMENTS FOR PERFORMANCE CHECK
Description
Performance
Requirements Application Example
Coaxial cable
Impedance, 50 Ω; length,
42 inch; connectors, bnc.
Steps 8 through 13.
a. TEKTRONIX part
012-0057-01.
Coaxial cable Impedance, 50 Ω, length,
18 inch; connectors, bnc.
Steps 12,13.
a. TEKTRONIX part
012-0076-00.
1X passive probe
Compatible with 5A-series
amplifiers used in the
Oscilloscope.
Step 14. a. TEKTRONIX P6101
Probe.
b.
TEKTRONIX P6062B
Probe.
Termination Impedance, 50 Ω; accuracy
within 2%; connectors, bnc.
Steps 9, 11,12. a. TEKTRONIX part
011-0049-01.
Tee connector
Connectors, bnc. Steps 12, 13.
a. TEKTRONIX part
103-0030-00.
Screwdriver Length, 3-inch shaft; bit
size,
3/32 inch.
Step 1.
a. Xcelite R3323.
PRELIMINARY PROCEDURE FOR
PERFORMANCE CHECK
1. Ensure that all power switches are off.
2. Check the rear panel of the oscilloscope to ensure
the indicated line voltage and the line voltage source are
the same.
INITIAL CONTROL SETTINGS
Set the following controls during warm-up time:
OSCILLOSCOPE
INTENSITY, FOCUS Set for well-defined trace
and normal brightness.
3. Ensure that all test equipment is suitably adapted to
the line voltage to be applied.
4. If applicable, install the TM 500-series test equip­
ment into the test equipment power module.
5. Install a dual-trace vertical amplifier unit into the left
vertical compartment of the oscilloscope.
6. Install a time-base unit into the horizontal compart­
ment of the oscilloscope.
AMPLIFIER PLUG-IN
Display
Position
CH 1
Volts/Div
CH 1 Cal
CH 1 Input coupling
Trigger
Mode
On
Centered
1
Fully clockwise
de
CH 1
CH 1
7. Connect the equipment under test and the test
equipment to a suitable line voltage source. Turn all
equipment on and allow at least 20 minutes for the
equipment to stabilize.
NOTE
Titles for external controls of the oscilloscope are
capitalized in this procedure (e.g. INTENSITY,
POWER).
TIME BASE PLUG-IN
Display
Position
Seconds/Div
Seconds/Div Cal
Swp
Mag
Triggering
Triggering Source
Chop
Centered
1
ms
Fully clockwise
Off
+ Slope, Auto Trig,
ac Couple
Composite
2-6
REV A JUL 1979