Tektronix 2213, Инструкция по эксплуатации

Страница: 45 / 225

Theory of Operation—2213 Service
Capacitor C644 charges rapidly to the new voltage
difference through R642 to produce a very narrow pulse
output across R642. When the holdo ff period ends, the
Q output o f U640B goes HI again and C644 charges in the
opposite direction through VR644. The resulting A lt Sync
signal is applied to the Channel Switching circuit to syn­
chronize the horizontal display w ith channel switching
transitions when using A L T V E R TIC A L MODE.
Delay Circuit
The Delay circuit, composed o f Q624, Q632, Q644,
Q650, Q652, U607D, and associated components, generates
the tim ing and gate signals required to produce the inten­
sified Sweep display and to provide the variable Sweep
delay. H O R IZO N TAL MODE switch S650 controls the
display mode (NO D LY, INTENS, or D LY 'D ), and DELAY
TIM E switch S660 selects the basic delay time (0.2 ms,
10 ps, or 0.5
ms
). The D ELAY TIM E M ULTIPLIER
control (R658) increases the possible delay available by up
to at least twenty times the basic delay.
NO D LY. With H O RIZO NTAL MODE switch S650 set
to the NO D LY position, the Delay circuit is disabled and
the Sweep starts immediately after the Swp Gate signal is
produced by U603B at pin 9. Pin D o f S650 is open, so pins
4 and 10 o f U620 are pulled HI through R608. When the
Swp Gate occurs, pins 1, 2, 5, and 9 o f U620 all go HI.
The HI on pin 5 is ANDed w ith the HI on pin 4, and U620
pin 6 goes LO to initiate a Sweep. The output o f the Delay
circuit is disabled by grounding the base o f Q644 through
pin A o f S650. This action holds the Dly Gate signal at the
collector o f Q652 at a HI logic level. With the Dly Gate
signal HI, a HI is also gated through U620 to pin 8 to bias
o ff CR620. Diode CR622 is then forward biased to enable
the Intens Level current from R622 to the Z-Drive line to
unblank the c rt fo r the Sweep display.
INTENS. With S650 set to the INTENS position, the
Delay circuit is enabled. No delay in the Sweep occurs in
this mode, but an intensified zone is displayed. The amount
o f delay between the start o f the Sweep and the start o f
the intensified zone is determined by the D ELAY TIME
switch setting and the M ULTIPLIER control position.
The intensified zone is generated by gating through
U607D to control the Z-Axis gating diodes, CR619 and
CR621 (see Figure 3-6). Pin 12 o f U607D is pulled HI
through R607 as pin H o f S650 is open. When the delay
tim e has elapsed, U607D pin 13 is also switched HI (by the
Dly Gate signal), and pin 11 goes LO. Diode CR619
becomes reverse biased, and CR621 passes the Intens Level
current to the Z-Drive line. The extra current is added to
3 -1 8
@
Figure 3-6. Simplified diagram of the Z-Axis Switching Logic circuit.