Kona Micro Gateway User Guide
T0008073_UG
Version 1.0
TEKTELIC Communications Inc.
Page 12 of 25
Figure 6: Battery Installation
2.6.
RF Cable Installation
The Kona Micro Gateway installation requires connection to a LoRa RF antenna. The antenna
attaches to the reverse SMA connector located on the side of the Gateway. Torque the connector
to 5 in·lbs. The Kona Micro is not protected from lighting surge as it is intended for Indoor use.
Do not connect to an outdoor antenna.
Note that the 3G/4G modem antenna is internal to the Kona Micro Gateway.
2.7.
Copper Ethernet Cable Installation
The Kona Micro Gateway Ethernet port may be used on a temporary basis for commissioning and
maintenance or may be permanently connected for backhaul and/or optional PoE.
The Ethernet cable must have minimum 24 AWG conductors and shall be rated for indoor
application according to local and national electrical codes.
2.8.
Proposition 65 Statement
WARNING: This product can expose you to chemicals including lead, beryllium, cobalt
oxide, nickel oxide, carbon black and lithium nickelate & nickel, which is known to the State of
California to cause cancer, birth defects or other reproductive harm. For more information, go
to
