TWM-1885 ANALOGUE ADDRESSED WIRELESS COORDINATOR
–
R01
TWM-1885 ANALOGUE ADDRESSED WIRELESS COORDINATOR
–
R01
8
If there are no events on the system when the menu is opened or the upmost menu is selected by
using the BACK button, the following main screen will be displayed initially:
FORWARD for the Menu
3.6.1
Events
This is the section under which the instant events that occur within the wireless system are listed. The
events are listed under three categories being
“Alarm”, “
Fault
”
and
“
Warning
”.
Events
To enter the menu:
“
Main Screen
” >
FORWARD
> “
Events
” >
FORWARD
Events
>1.Alarm
2.Fault
3.Warning
Any category can be selected from the
“
Events
”
screen shown above, and the devices under the
selected category are listed. Example
: “
Fault
”
category is selected in the following figure and the
devices in fault state are listed.
Fault (2)
>1.Coordinator
ID:18850601200001
2.Detector
ID:18502001200015
To navigate through the device list, use the DOWN and UP buttons on the menu. Go to sub-menu by
pressing the FORWARD button in order to read the details of faults. Example: Coordinator is selected
and its fault detail is displayed. On the address line, the number in brackets is the address in the
addressed system and then the address in the wireless system. On the following lines, the fault states
of the respectively selected devices are listed. If there are more than one fault states, they will be listed
one under the other.
