TD-1/11-102
TFD 1430
4 Wire Optical Smoke Detector
TFD 1450
4 Wire Optical Smoke + Heat Detector
Installation and User Manual
Publish Date: 15/4/2011
IMPORTANT WARNINGS
GENERAL
Before using the device read this manual carefully. Keep it
just in case of necessity.
Abide all the rules and precautions stated in the manual.
Follow all the instructions one by one.
Keep the devices away from water and moisture.
CONDITIONS
Do not energise the device above or below the given limits
of extreme hot or cold conditions.
Temperature:
Between 0
°
C and +55
°
C
Relative Moisture:
%95 at +40
°
C
Air flow limit:
Below 600 meters/min
SERVICE
Do not try to fix the device on your own, Removal of cover
may end up with electricity shock.
In case of any defect or malfunction, contact with your dealer
or with authorized service. All the technical interventions has
to be done by technicians of service company.
MALFUNCTIONS FOR TECHNICAL SERVICE
In case of any malfunction or below conditions contact with
your authorized service.
When Mains cable or the plug is harmed,
Contact of device with a fluid,
Exposure of rain and water,
Fell down of device or harmed outer cover,
Serious performance fall on the device,
Depending on the instructions stated in manual, if your
device not working properly, further usage or possible
wrong usage may cause other malfunctions . Contact
with your authorized service in such terms.
SPARE PART
If the repair will be done by spare parts, to avoid fire,
electricity shock or any other hazardous conditions, Make
sure your service is using original parts or parts compatible
with your equipment.
SAFETY CHECK
To make sure if your device working properly and in safe
conditions or not demand service from your dealer to check
devicefunctionality.
INSTALLATION AND CONNECTION
1. Remove the head of the detector attached to base by
turning it counter clock wise until you reach the short line
on the base(1),then pull it off(2).
2. Use at least 2 opposite ones from 4 of the screw holes
on the base to fasten it.
3. Do the wiring according to schematic shown below. The
order of cables do not make any difference. There is no
(+/-).
4. Place the detector head back. Make sure the short line
on head fits with long one on the base.
5. Energise the detector. If there is no alarm condition the
LED on detector flashes once every 10 secs to show it is
working at that moment. .
TEST
