Teknatool nova ORION 55250, Руководство по эксплуатации

Страница: 16 / 38

16
128-1019-004
▪
Forward and reverse state
▪
Current state of the lathe
▪
The second set of favourite speeds will not be
displayed.
▪
When the motor is off, set RPM of the lathe. This will
change to the actual RPM of the lathe spindle when
the motor is turned on.
▪
Forward and reverse state
▪
Current state of the lathe
Operating the Lathe
Starting Operation
When the main power switch has been turned ON, the LCD screen on the HMI will display the texts shown below:
Additionally, the following screen with be shown at the end of the starting sequence if the braking function is enabled on
the lathe. This message can be cleared to proceed on the lathe home screen by pressing any key on the HMI. The home
screen will be shown once the starting sequence is completed.
Running the Lathe
Press the
<ON> key while on the home screen to
start the motor.
The motor will accelerate to its set speed and keep
its set speed.