Teknatool nova ORION 55250, Руководство по эксплуатации

Страница: 10 / 38

10
128-1019-004
Secure the headstock onto the lathe bed by using the 8mm flat wide
washer and M8 hex head bolt included in the packaging.
Insert the bolt and washer from underneath the stand through the
hole and thread the bolt onto the headstock centre pin.
➢
Note: A hex socket extension may be needed to tighten this bolt .
Locking the headstock into place
The headstock is locked into place by the headstock locking pin.
1. 2.
Insert the hedstock lock pin into the bore on the lathe bed as
shown in the above image.
Hand tighten until it becomes firm Further tighten the headstock lock pin by using the
operating bar until firm to ensure the headsock is
locked in place.
WARNING!
Do not over tighten as it may cause damage to the
lathe bed.