06
T4DF545X, T4DF545BX
— Always pull out the plug during a power failure or when cleaning. Wait for 5 minutes or
longer when reconnecting the plug. It may damage the compressor due to continuous
start.
2.4 Care and Cleaning
Warning!
Risk of injury or damage to the appliance.
— Before maintenance, always switch the power off at the power outlet of the appliance and
disconnect the mains plug from the socket.
— Never spray and/or rinse the refrigerator with water and ensure that the refrigerator isn’t
installed in a wet environment so as not to affect the electrical insulation of the refrigerator.
— Do not use steam to clean the appliance.
— Before first use, clean the appliance with a moist soft cloth. Only use neutral detergents.
Do not use abrasive products, abrasive cleaning pads, solvents or metal objects.
2.5 Product Disposal
Warning!
Risk of injury or suffocation.
— Disconnect the appliance from the mains supply.
— Cut off the mains cable and discard it.
— Remove the doors to prevent children and pets from becomming trapped within the
appliance.
2.6 Transport
— Always move the appliance cautiously and in an upright position.
— The appliance must not be tilted on an angle greater than 45 degrees. Allow the appliance
to stand vertically after transportation for a few hours before plugging in to a power outlet.
— Do not use the appliance door or door handles to lift the appliance.
2.7 Installation Positioning
— Ensure that your appliance is installed on solid, hard and flat ground, in a level position.
— Please do not place the appliance on a slope, soft carpet or wooden floor.
— Your appliance should only be installed within an internal environment. Do not install the
appliance outdoors.
— Ensure there is adequate air circulation around the refrigerator. Above the refrigerator
there should be a 30cm allowance, and between the sides and rear a 10cm allowance.
This allows for the doors to open freely and any heat to disipate.
— Avoid placing the refrigarerator near any heat sources and in direct sunlight.
Level Adjusting
— If the floor is obviously uneven, your appliance feet need to be adjusted. If your appliance
isn’t level, it will cause your appliance to vibrate, and potentially move from its position.
Warning!
When pushing the refrigerator into position, please be careful to ensure the
power cable isn’t damage or squeezed.
2.8 First Use
— When the refrigerator is connected to power for the first time, the refrigerator will be in it’s
default status. The temperature display will show the actual temperature of the fridge and
freezer.
— The refrigerator has a power-down memory mode. In the even power is lost or the
refrigerator is switched off, when power is restored it will remember the last temperature
settings set.
— You can select a mode of operation: Intelligent Mode or Manual Mode. In Intelligent mode
the settings are determined by the fridge, whereas Manual mode allows you to define the
temperature settings for both the fridge and freezer components.
— Please allow several hours for the fridge/freezer to reach your desired temperatures. This
should also be kept in mind when changing the temperature settings at any time in the
future.
Safety Notes Continued
