Teka FGKST 85 .. FB, Инструкции по монтажу и использованию

Страница: 19 / 100

223693 19
4. Fitting
4.1 Worktop cut-out
Carry out all cutting out of furniture units and worktops before fitting the
appliance, and remove all sawdust and chips.
The dimensions of the worktop recess can be seen in the dimension
drawing (figs. 1+2).
The cut sections should be sealed with a water-repellent protection
paint.
The worktop and the hob must be fitted horizontally. A tilted hob is
under tension and this increases the danger of breaking.
4.2 Installation
Before installing the hob, check that the all-round hob seal has no gaps.
If the hob is installed in a worktop with a ceramic or similar cover (tiles), remove the hob seal and seal the hob
from the worktop with a plastic seal, such as heat-resistant silicone rubber.
Important! The surface temperature exceeds 95°C. To avoid a hazard, underbench access must be
restricted. Refer to the installation instructions.
Important! If the cooking surface is located above furniture parts (side panels, drawers, etc.), then an
intermediate bottom must be inserted in order to prevent accidental contact with the
underside of the cooking surface. The intermediate bottom may only be capable of removal
by means of tools and must be attached with a minimum distance of 20 mm to the underside
of the cooking surface so that the mains connection cable does not touch the underside of
the cooking surface (fig. 4).
If the cooking surface is to be inserted over a built-in baking oven, then it must be equipped
with a cooling fan. An intermediate bottom is not necessary in this case.
No cross-bars may be in the area of the cut-out underneath.
Place the hob carefully into the cut-out and fasten it to the worktop with the fasteners.
Make sure that the worktop and the hob are horizontal. In addition, make sure that no liquids can penetrate
between the edge of the hob and the worktop or between the hob and the wall and come into contact with any
electrical appliances. Use sealing sections, strips, agents, etc. This means that it can be installed with its rear side
and one of the other sides in contact with room or unit walls of any height. The other sides may only be in contact
with furniture or other appliances with the same height as the appliance.
Tighten the screws with a hand screw driver only; do not use a battery-operated screw
driver.