TEK Biomasse EBONY, Инструкция по эксплуатации

Страница: 4 / 32

4
1.
G
ENERAL
C
ONSIDERATIONS
TEK Biomasse ® is a registered trademark, whose
air conditioning equipment is manufactured by
Vitor Monteiro Lda., and tested in accordance with
European reference safety standards.
1.1. Symbology
The following graphic symbols are used in this
manual:
- Tips and useful information,
- Danger, important information to avoid
accidents.
Attention: the symbols indicate important
information in order to make the manual more
lucid. However, this does not relieve the user of
the obligation to comply with requirements that
are not marked with a graphic symbol.
This manual is divided into two parts: one for the
user and one for the installer. Both parts contain
important and significant information for safety
issues, therefore, the user should read both parts
of the manual. We are not responsible for any
damage caused by failure to follow these
instructions.
1.2. Use
This equipment is a stove intended for domestic
heating and is reserved for indoor installation. It
must not be operated by anyone unfamiliar with
this manual as well as by children, the elderly and
others whose physical, mental and intellectual
capacities are impaired.
Failure to observe these rules can cause property
damage, threat to human life and health and
domestic animals.
1.3. Packaging of documentation
This manual, as well as any other applicable
documentation, must be stored diligently so that
it is available at all times. In case of moving or
selling the equipment, the documentation must
be attached and forwarded to the new
user/owner.
2.
S
ECURITY WARNINGS
The instructions contained in this manual must be
followed, both by the Technician (Installer,
Maintenance) and by the User. Some of the
warnings, if not followed, void the warranty
contract.
2.1. Installer Technician and
Maintenance Manager
The installation of the stove is exclusively
reserved for specialized technicians.
The responsibility for installing the equipment
cannot be considered the responsibility of Vitor
Monteiro, Lda.
In case of need for works at the installation site
of the stove, these are the responsibility of the
user and whose expense falls on the same. The
works, before being carried out, must be
approved by the user.
The technical responsibility for the installation
rests with the installer, who is asked to carry out
the chimney and air intake checks and carry out
the proposed installation solutions correctly.
Installation of the equipment must comply with
all national and European regulations, standards
and laws.
The equipment must be installed on a surface
capable of supporting its weight.
Confirm that the chimney design and air intake
are in accordance with the installed equipment.