TEK Biomasse EBONY, Инструкция по эксплуатации

Страница: 15 / 32

15
Air flow *
-
Primary airflow velocity; visible Input was set to " Air Flow
Sensor "
Fan*
[rpm] Combustion fan speed; visible if P25 ≠ 0
Auger *
[s] Power auger connected; visible if P81 ≠ 0
Receive
[nr] Selected combustion recipe; visible if P04 > 1
Service
[H] Service ' message; visible if T66 > 0.
Cleaning
[H] Timer for cleaning the greenhouse; visible if T66 > 0.
Working hours *
[nr] Work hours.
Ignitions *
[nr] Number of ignitions/ignitions.
Product _ Code 559-
xyzt *
Firmware Code and Revision: FYSr02000001.xy
8.9. User Menu 1
Access to the menu is done by pressing P3
Power
Combustion
By entering this menu, you can change the combustion power of the
system. You can configure it in automatic or manual mode: in the first
case, the system chooses the combustion power; in the second case, the
user selects the combustion power of their choice. On the left side
From the screen, the combustion mode is displayed (a = automatic
combustion, m = manual combustion) and the operating power of the
system.
Heating
By entering this menu, you can change the heating power. You can
configure it in automatic or manual mode: in the first case, the system
chooses the combustion power; in the second case, the user selects the
combustion power of their choice. On the right side of the screen the
heating mode is displayed (A = automatic, M = manual) and the
corresponding power.
By setting parameter A04 = 1, the menu is not displayed.
Thermostats Living room
Menu to change the main thermostat value. Only displayed if a19 = 1.
Remote
Menu that allows changing the value of the remote thermostat; is displayed
only
If an input is set to remote room probe and p69 > 0.
Chrono Allows you to program and enable the ignition/extinguishing system. It's composed by
2 submenu.
Modality
Allows you to select the mode, or disable all programs.
- Enter edit mode with P3 key
- Select the mode of your choice (Daily, Weekly or
Weekend)
- Activate / deactivate chrono mode with the P2 key
- Save settings with P3 key
Program