TEK Biomasse EBONY, Инструкция по эксплуатации

Страница: 8 / 32

8
The functioning of the stove depends largely on
the quality and conservation conditions of the
pellets, for this reason they must be stored in a
dry place where they do not reach too low
temperatures.
Poor packaging of the pellets can lead to the
breakdown of particles and create sawdust.
Sawdust is responsible for the malfunction of the
power system and can block it.
We recommend storing a few bags of pellets
in a warm and dry place, because cold pellets
(5º.C) and/or damp reduce the calorific value of
the fuel and cause more dirt, requiring more
rigorous maintenance and cleaning.
6.
U
NLOADING AND TRANSPORT
The stove must be transported vertically without
rocking during the entire transport process.
The stove's brazier as well as other components
can come loose causing damage to the product.
The stove's packaging must not be impacted or
hit by other objects or equipment, under penalty
of causing damage that will compromise the
stove's future operation.
Make sure that the means of transport used has
a capacity greater than the weight of the stove.
7.
I
NSTALLATION
To obtain the best performance from the stove
and uniform heating of the room, you must
comply with some essential rules.
Improper installation will compromise the safety
and proper functioning of the stove.
When installing the equipment, all national and
local regulations, as well as European standards,
must be observed.
7.1. Leveling the stove
The stove must be leveled using a bubble water
level and using the rubber adjustment feet
provided.
7.2. Installation constraints
It must be safeguarded that no mechanical
exhaust fans or collective ventilation ducts are
installed at the installation site.
In any case, it must be safeguarded that the
installation site is not in a depression, preventing
the simultaneous operation of the systems
mentioned above, since this will compromise the
normal functioning of the stove and possible
release of dangerous fumes. Check point 13-
Models and technical characteristicsfor more
information.
7.3. Stove installation location
The following figure indicates the minimum
distances (in centimeters) from combustible
surfaces that must be observed when installing
the stove. In the case of non-flammable
walls/objects these distances can be reduced by
half.
Figure 2- Minimum dimensions to respect in relation to
adjacent surfaces
The floor protection to support the stove must
guarantee fire resistance in accordance with
European standards. Never place the stove
directly on wood, carpet or other combustible
materials.