TEK Biomasse EBONY, Инструкция по эксплуатации

Страница: 7 / 32

7
5.
F
UEL
100% pressed pine wood pellets certified
according to the EN PLUS A1 standard are the
only fuel allowed for use in this boiler.
The pellets used must be certified and in
accordance with EN Plus 14961 or 17225-2.
5.1. Fuel characteristics
Pellets are produced by pressing wood chips and
sawdust. They are obtained without the addition
of any foreign substance, such as adhesives,
lacquers or synthetic substances.
Pressing through a matrix of holes and the heat
produced by friction and pressure, activates
natural wood binders that in this way ensure the
shape of the pellets even without the addition of
binders.
The production and consumption of pellets is
based on the rational use of renewable energy
with zero impact on the CO
2 cycle,
which respects
environmental protection standards.
This is the only fuel indicated for this equipment.
Yield and power vary depending on the quality of
pellets used.
For correct operation you must use pellets
according to the characteristics below.
Technical Fuel Information (Pellets)
Diameter 6mm
Length 10 to30 mm
Density in the bag min. 650 kg/m 3
Humidity Max. 10%
Max. from the ashes Max. 1.5%
Max. from the dust Max. 2.3%
Calorific value of various fuels:
Wood pellets 4.9 kWh /kg
Wood chip ± 850kW.h/m 3
Soft woods ±1500 kW.h /m 3
Hard woods ±2000 kW.h /m 3
Coal 7 kW.h /kg
Naphtha 7.5 - 8 kW.h /kg
Natural gas 9.5 - 10.2 kW.h /m 3
Liquid gas 12.8 kWh /kg
The stove is equipped with a hopper (deposit) for
pellets with a capacity for 1 bag of 15 kg.
The supply of pellets must only be carried out
through the door that gives access to the cargo
compartment located at the top. This should only
be opened to load the pellets and only when it is
not in operation, it is not advisable to supply
pellets with the stove in operation.
Figure 1- Ebony charging cover
5.2. Pellet storage