TEK Biomasse EBONY, Инструкция по эксплуатации

Страница: 14 / 32

14
State Code State Code
OFF - Operation -
Verification Check Modulation mod
Ignition-Preheating Phase on 1 Standby STBY
Ignition-Pre-Charge Phase on 2 Safety SAF
Ignition-Fixed Phase on 3 Extinction OFF
Ignition-Variable Phase on 4 Block Alt
Stabilization on 5 Recover the ignition rec
8.7. Messages
Description of messages Code
Viewing the status of the temperature probes. The message displayed in the
Check-Up indicates that the temperature reading on one or more probes is equal
to the minimum (0 °C) or maximum value (depends on the probe considered).
Check that the probes are not open (0 °C) or that they are short-circuited
(maximum value of the temperature scale). probe
Open door. You must close the door! door
Delay in stopping the equipment. The equipment was turned off when it was on.
Wait for this operation to complete. OFF DEL
This message notifies you that the planned hours of operation (parameter T67)
are reached. Proceed to cleaning. To clear the warning, access menu 1 and
perform the Cleaning
Reset ( rCLr )
CLr
Periodic cleaning running. Information message that the equipment is
performing periodic cleaning. PCLr
Supply pellets rFiL
Open hopper thermostat. FLAM
Automatic periodic cleaning running PCLr
- Error codes:
See point 10- Error codes.
8.8. Views.
Display Un
Description
K100
T. Exhaust
[°C] Smoke temperature
T. Room
[°C] Local temperature; visible if A19=1
T. Remote room
[°C]
Remote ambient temperature; visible if remote probe is
configured and P69>0