10 TEGAM WAY • GENEVA, OHIO 44041 440-466-6100 • FAX 440-466-6110 • www.tegam.com
4-5
Section IV - Operating Instructions
Running a Calibration
Once a power sensor template is loaded, PS-Cal displays one tab for each required test step. The exact
steps required for each power sensor and each measurement methodology vary. These tabs are loaded in
order of operation from left to right.
Figure 4.6 Running a Calibration
Two default tabs are loaded with every power sensor. The first is the UUT tab containing information
about the Unit Under Test (UUT, also known as Device Under Test, DUT) and the work order. Data such
as the UUT Serial number, Asset number, Job number, and the Calibration Technician (Cal Tech) who
performed the calibration must be updated on this tab.
Figure 4.7 Calibration Default Tabs
The last tab is the Cal Report tab, which is used to print the report data for the calibration. Once all the
steps between the UUT tab and the Cal Report tab have been completed, the data is ready to print.
