iv.
Connect power to Inlet Tube/Heaterinside the enclosure
2.2. Connect Mains Power
Locate the power connector terminal which is situated outside the enclosure at the bottom.
The power supply will already be wired to the connector however the cable to connect to
mains power needs to be wired.
Caution: The high voltage mains supply must be wired by a certified electrician
in compliance with local electrical regulations
.
3.
Reconnect into the connector
ensuring the plugs are fitted securely
and the nut gland tightened.
Plug
Nut gland
Connector
Terminal block
Neutral
(Blue)
Earth
(Yellow/Green)
Live
(Brown)
2.
Feed the power cable through the nut gland
plugs and connector and wire the cable to the
terminal block according to the diagram.
Note: To remove the terminal block from inside the connector unclick it from the casing by
turning it slightly then pull out
1.
Unscrew the nut
gland to loosen the
terminal block and pull
connector apart
Power cable
from heated inlet
