TeeJet Technologies AEROS 9040, Руководство пользователя

Страница: 69 / 126

61
98-05304-EN R2
Aeros 9040 field computer
HOME
SE
TUP
GUID
ANCE
FULL SCREEN
INTR
ODUC
TION
GNSS
RA
TE C
ONTR
OL
APPENDIX
IMPLEMENT
►Connection point lateral offset direction

– define the
direction, either left or right, from the centreline of the machine
to point while facing in the machine's forward direction
►Connection point lateral offset distance

– define the
distance from the centreline of the machine to point
►Implement in-line offset direction

– same direction as
Aeros Connection point in-line offset direction
►Implement in-line offset distance  – calculated based
on Aeros Connection point in-line offset distance

and
ISOBUS Sprayer B=Section X-offset

entries
►
 +  = 
►Implement lateral offset direction

– same direction as Aeros
Connection point lateral offset direction
►Implement lateral offset distance

– same value as on Aeros
Connection point lateral offset distance
Trailed – always rear mount
Figure 6-34: Trailed – always rear mount
– Centre of the GNSS antenna
– Connection point
– Centre of the front axle of the trailed implement

– Connection point in-line offset direction/distance

– Connection point lateral offset direction/distance

– A=Connection X-offset distance

– B=Section X-offset distance

– Implement in-line offset direction/distance
ISOBUS Sprayer settings:
1. Press UNIVERSAL TERMINAL bottom tab .
2. From the Main setup screen , select
Machine
.
3. Select
OEM
then enter the access code as needed.
4. Select
Implement Geometry
:
5. Establish values for:
►Connector type:
Trailed
►A=Connection X-offset

– measured in parallel to the
centreline of the machine, define the distance from point to
the center of the front axle of trailed implement
►B=Section X-offset

– measured in parallel to the centreline
of the machine, define the distance from the center of the front
axle of trailed implement to the implement
Aeros settings:
1. Press SYSTEM SETUP bottom tab .
2. Press CONFIGURATION side tab .
3. Press
Implement
.
4. Select Implement type
Straight
.
5. Press Implement type NEXT PAGE arrow to set up specific
implement options.
6. Establish values for:
►Connection point in-line offset direction  – define the
direction as
Backward
based on ISOBUS Sprayer
connection type
►Connection point in-line offset distance  – measured in
parallel to the centreline of the machine, define the distance
from the GNSS antenna to point
►Connection point lateral offset direction  – define the
direction, either left or right, from the centreline of the machine
to point while facing in the machine's forward direction
►Connection point lateral offset distance  – define the
distance from the centreline of the machine to point
►Implement in-line offset direction

– same direction as
Aeros Connection point in-line offset direction
►Implement in-line offset distance  – calculated based on
Aeros Connection point in-line offset distance

, ISOBUS
Sprayer A=Connection X-offset  and ISOBUS Sprayer
B=Section X-offset  entries
►

+

+

=

►Implement lateral offset direction  – same direction as Aeros
Connection point lateral offset direction
►Implement lateral offset distance  – same value as on Aeros
Connection point lateral offset distance