Tecumseh AH520 -, Руководство пользователя

Страница: 28 / 68

25
CLIP *
* USED ON SOME MODELS
"V"ROPE WEDGE
BRACKET
ROPE CLIP
KEY*
PAWL SPRING *
BRAKE
PAWL
PIN
STRUT
SPRING
ASSY.
LOCKING PAWL*
STARTER HANDLE
ROPE
PULLEY
GUIDE BRAKE ENDS
THROUGH SLOT
WHEN PIN IS REMOVED STRUT
WILL ROTATE 45
o
CLOCKWISE
6. If the starter is equipped with a locking or delay
pawl and spring, make sure these are in place before
grasping the gear and spring capsule assembly
and sliding it into the bracket. Make sure the legs
of the brake spring are positioned in the slots of
the bracket.
7. Feed the rope end under the rope guide and hook
it into the "V" notch. Remove the pin and the strut
will rotate clockwise against the bracket.
8. Insert the new center pin by pressing or driving
the pin firmly in place. Reinstall the starter assembly
on the engine.
REWIND STARTER MOUNTED IN HOUSING
DISASSEMBLY PROCEDURE.
1. Pull rope out to untie knot in rope and slowly release
spring tension.
2. Remove “E” clip, brake, brake spring, starter dog
and return spring.
3. Lift out pulley; rewind spring is located in the housing.
Replace all worn or damaged parts.
RETURN SPRING
HANDLE INSERT
HANDLE
STARTER ROPE
REWIND SPRING
PULLEY
HOUSING
ASSY.
TRUARC
"E" CLIP
BRAKE
STARTER DOG
BRAKE SPRING
ASSEMBLY PROCEDURE.
1. Hook loop of spring into housing and wind in housing
in a counterclockwise direction. The spring should
have a light coating of grease on it.
2. Place pulley into housing.
3. Install dog spring and dog in starter pulley in the
socket closest to the rope hole in pulley.
4. Replace brake spring, brake and install “E” clip.
5. To put tension on spring, wind pulley
counterclockwise until tight, then allow to unwind
until the hole in the pulley lines up with the eyelet
in housing, then install rope and handle.