Tecumseh AH520 -, Руководство пользователя

Страница: 27 / 68

24
5. Pinch the two legs of the plastic retainer together
and start into the center shaft hole.
6. Rotate the retainer so the two tabs on the bottom
of the part fit between the dog and pulley hub (left
side of the dog). Push the retainer in until the leg
prongs pop out of the center shaft.
7. Turn the starter over and snap the locking tab between
the retainer legs, replace the top decal.
NOTE: Refer to Service Bulletin 122 for metal locking
tab.
8. Wind the starter pulley counterclockwise four or
five turns to pre-load the recoil spring and thread
the rope through the starter housing eyelet. Pull
enough rope through to tie a temporary knot in the
rope. Reattach the starter handle to the rope using
a left-hand knot. Untie the temporary knot and allow
the rope to recoil.
VERTICAL PULL STARTER, VERTICAL
ENGAGEMENT TYPE
DISASSEMBLY PROCEDURE
1. Pull out enough rope to lock the rope in the "V" of
the bracket.
2. Remove the handle if necessary by prying out the
small staple in the handle with a screwdriver.
3. Place the starter bracket on the top of a deep well
socket that is large enough to receive the head of
the center pin. Use an arbor press to drive out the
center pin.
4. Rotate the spring capsule strut until it is aligned
with the legs of the brake spring. Insert a nail or
pin no longer than 3/4" (19.05 mm) through the
hole in the strut so it catches in the gear teeth.
This will keep the capsule in the wound position.
5. Slip the sheave out of the bracket.
CAUTION: DO NOT ATTEMPT TO REMOVE THE
SPRING CAPSULE FROM THE SHEAVE
ASSEMBLY UNLESS THE SPRING IS FULLY
UNWOUND.
6. Squeeze and hold tightly by hand the spring capsule
at the outer edge against the gear sheave.
7. Remove the retainer pin from the strut and slowly
relieve the spring tension by allowing the spring
capsule to rotate slowly under control, until completely
unwound. The spring capsule can now be removed
from the gear sheave.
ASSEMBLY PROCEDURE
1. Feed the new rope through the hole and tie a left-
handed knot on the rope end. Make sure the rope
and knot do not protrude from the knot cavity and
bind the pulley rotation.
PIN
ROTATE
COUNTERCLOCKWISE
STRUT
ORIGINAL INSTALLATION WITH STAPLE
INSTALL NEW
ROPE BY TYING
LEFT-HAND
KNOT
LEFT-HAND
KNOT
PRY STAPLE
OUT TO
REMOVE OLD
ROPE
REINSTALL
LEFT-HANDED
KNOT
ROTATE SPRING
4 FULL TURNS
SPRING HOOKED ON
GEAR HUB
STARTER SPRING
END
GEAR HUB
2. Wind the rope on the sheave assembly clockwise,
viewing the gear from the gear side of the sheave.
3. Reinstall the brake spring, being careful not to
spread the spring more than necessary.
4. Install the spring capsule, making sure the starter
spring end hooks on the gear hub.
5. Wind the spring four full turns and align the brake
spring legs with the strut as shown. Insert the pin
in the strut.