2.Press & hold the [VF] button with [
] advancing to scan from one station to
another, staying on each station for about 5 seconds.
3.To stop the auto browse function, simply press the [VF] button.
Note:
While operating the “Auto Browse Station” function, you can press the [M]
button anytime to store the station into memory, and the radio will keep on auto
browsing the next available station.
WORKING WITH STATION MEMORIES
There are total 550 preset memories within the unit. 100 preset memories for each FM,
MW, and LW band, and 250 for SW.
FM ATS:
1. Fully extend the telescopic antenna and press the [FM]
button to select FM band.
2. Press & hold the [FM] button with “PRESET ” flashing and
the frequency start running, then you can scan and store
your desired stations within the present band. When the
frequency stop running, it means the ATS operation has
been completed; then rotate the [TUNING] knob for those
scanned and stored stations.
MW/LW ATS:
Press the [MW] button to select MW/LW band, then follow step 2 of FM ATS.
SW ATS:
Fully extend the telescopic antenna and press the SW[ ] or [ ] button to select SW
band. There are two modes for SW ATS tuning:
Mode A:
Press & hold the [ ] button to ATS the stations within all meter bands
Mode B:
Press & hold the [ ] button to ATS the stations within present meter band
only.rotate the radio for better location (MW & LW).
Notes:
1. During ATS process in FM, MW / LW or SW (mode A), pre-stored radio stations
will be replaced automatically by the new searched stations.
2. With ATS in SW (mode B), those existing memories will not be replaced; all the
newly found radio stations would be stored in the blank memories addresses.
3. If there is too many interference in you surrounding or many mirror/blank station
being stored during ATS, you should contract the telescopic antenna (FM & SW)
or rotate the radio for better location (MW & LW).
METHOD 2: MANUAL STORING STATON
1. Select band and tune to your desired station.
