Tecomec GEOline 8410073, Инструкция и руководство пользователя

Страница: 46 / 68

ISOBUS ECU 1224 User and Instruction maual
|
P00801545 Rev:02 SW:1.0.0
45
The orange color is used for the section currently open, but not spraying because the main valve is
closed (in the above case only the right left section is closed, and all the other open).
When the user opens the main valve all the orange sections will start spraying and the grey ones
will remain closed.
10.5.2 Dependent Mode
Main valve operates as a master driving also the status of all the section valves.
When the main valve is closed, all the section valves will be closed and when the main valve is
open all the section valve will be open (the orange color in the WORK page will be never used for
sections in this case).
10.6 Rate indicator
The central area of the WORK page, contains an indicator that display the currently measured rate
and its desired setpoint (defined by user in manual mode or by TC in auto mode).
Figure 35
Inside the meter, the rate setpoint indicator is always positioned in the center of the indicator (red
vertical line in the above figure). This implies that the maximum value that the meter can show
corresponds to 2 x SETPOINT (the numerical value may be greater).
This logic is independent from the functioning mode (manual or automatic).
10.7 Tank Replenishment
The tank can be refilled at any time.
If ISOBUS ECU 1224 is configured to use a tank level sensor and it was correctly calibrated (refer to
Chapter 9.7), the new quantity is automatically shown on the top-right area of the WORK page
(refer to Figure 20 Figure 21).
SETPOINT
CURRENT
VALUE