Tecomec GEOline 8410073, Инструкция и руководство пользователя, Страница: 41 / 68

ISOBUS ECU 1224 User and Instruction maual
|
P00801545 Rev:02 SW:1.0.0
40
10 IN FIELD USAGE
ISOBUS ECU 1224 is dedicated to sprayer machine, and at least a Virtual Terminal device (VT),
necessary to display the sprayer application user interface.
The tractor ISOBUS network may also include a Task Controller device (TC), generally integrated in
the terminal that implements the VT. In this case the sprayer application implemented in the ECU-
1224 can offer increased functionalities.
The sprayer application can work in two different modes: Manual Mode and Automatic Mode.
Refer to Chapter 10.4.1 for a detailed description of the sprayer functioning mode, but at this
stage it is important to notice that the manual mode is always available (only a connected VT is
necessary), meanwhile the automatic mode works only when a TC is present.
In case TC and a GPS antenna (that give the real-time position of the sprayer) are present, the
ECU-1224 driver can work using prescription maps. This functionality shall be implemented in the
TC side, but the ECU-1224 configured in automatic mode is able to receive a flow-rate set-point
variable continuously according to the current position. Please refer to Virtual terminal manual for
this topic.
10.1 Display
ISOBUS ECU 1224 sprayer application, uses the VT display available on the tractor as user interface
(refer to Chapter 9 for a detailed description of all the
“ application pages ” ).
According to the ISOBUS standard, the VT screen is divided into 3 different areas, as show in the
Figure 23
Depending on the configuration of the VT used, the Soft-keys mask may be on the left and right
side of the Data mask or both on the same side (left or right).
Depending on the Virtual terminal, you can activate software functions using physical buttons
located on the border of the display, or directly by the touchscreen if available.
Soft-keys
mask
Data
mask
Figure 30