Technogym Recline 600 XTPRO, Руководство по техническому обслуживанию

Страница: 54 / 86

RECLINE 600 XTPRO: Service & Maintenance Manual - rev. 1.1
Page 7.12
7.11. DISASSEMBLING THE ALTERNATOR
Figure 7.11-1
Carry out the procedures described in paragraphs
7.9. “Disassembling the right and left side
casings”
1. Disconnect the ALTERNATOR cables.
2. Loosen nut
a of belt tension rod b using a 17-
mm wrench.
3. Unscrew bolt c which fixes belt tension rod b
to the machine frame using a 17-mm wrench.
4. Loosen dowel
d using a 4-mm hex T-wrench.
5. Move the ALTERNATOR until belt
e can be
removed.
To facilitate the operation, the belt can
first be removed from the pulley.
6. Loosen lock nut (not visible in the figure at
left) of alternator pivot f using a 19-mm
wrench.
7. Unscrew alternator pivot f using an 8-mm
hex T wrench, while at the same time
backing off the lock nut (not visible in the
figure at left) of alternator pivot
f .
8. Remove the ALTERNATOR.
To reassemble the ALTERNATOR, carry out the
above steps in reverse order.
After completing the procedure, adjust
the belt tension and alignment as
described in paragraphs 8.1. 8.2.