Technogym Recline 600 XTPRO, Руководство по техническому обслуживанию

Страница: 53 / 86

RECLINE 600 XTPRO: Service & Maintenance Manual - rev. 1.1
Page 7.11
7.10. DISASSEMBLING THE ELECTRONIC CIRCUIT BOARDS
Figure 7.10-1
Carry out the procedure described in paragraph
7.9. “Disassembling the right and left side
casings”, removing only the right side casing.
1. Using a 7-mm wrench, unscrew the 8
hexagonal-head fixing screws of the grid
which protects the electronic circuit boards.
2. Remove the protection grid.
To disassemble the POWER SUPPLY
a :
1. Disconnect the 2 connectors CN1 and CN2.
2. Remove the 4 clip fasteners.
3. Remove the circuit board.
To disassemble the ALTERNATOR
INTERFACE BOARD
b :
1. Disconnect the 3 connectors CN1, CN2 and
CN3.
2. Manually unscrew the fixing studs of the
protection grid.
3. Remove the circuit board.
Figure 7.10-2
To disassemble POWER RESISTORS c :
Check that the resistors are not hot.
1. Unscrew the 2 locknuts on cable CX-5/L
using a 7-mm wrench.
2. Unscrew the 2 locknuts on each resistor
using a 10-mm wrench.
3. Remove the resistors.
To reassemble the ELECTRONIC CIRCUIT
BOARDS, carry out the above steps in reverse
order.