Technogym Recline 500, Руководство по техническому обслуживанию

Страница: 128 / 182

RECLINE EXCITE: Service & Maintenance Manual - rev. 2.4
Page 7.34
7.18. DISASSEMBLING THE SADDLE
Only 500i and 500i SP models
Figure 7.18-1
1. On both side, disassemble the 2 pulleys on
which the saddle moves, backing off the nut
a using a 17-mm wrench and locking down
the eccentric pin
b using a 24-mm wrench.
2. Remove the saddle from the equipment.
To reassemble the saddle, carry out the above
steps in reverse order.
After completing this operation, adjust
the saddle position as described in
paragraph 8.5. “Saddle sliding”.