Technogym BIOSTRENGTH LINE, Руководство по техническому обслуживанию

Страница: 606 / 646

BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 8.32
8.14. ADJUSTING THE CURRENT LIMIT ON THE WSMI AND
SAMI BOARD
This operation is the same for all machines.
Figure 8.14-1
1. To adjust the current limit setting, turn the
trimmer screw P1 on the IMS and IMP board
using a small flat screwdriver, until the ideal
level is reached.
WARNING: do not adjust this trimmer
unless strictly necessary. In any case,
always check the reason for the need to
increase the current (increased friction,
mechanical parts that obstruct
movement, electrical problems on the
motor) before adjusting the trimmer.
CAUTION: every time the trimmer is
adjusted to raise the level of current
absorbed by the motor, make sure it is
not greater than 5 A, the maximum
value allowed by the motor.