Technogym BIOSTRENGTH LINE, Руководство по техническому обслуживанию

Страница: 550 / 646

BIOSTRENGTH LINE: Service & Maintenance manual - rev. 2.1
Page 7.376
7.9.29. D
ISASSEMBLING THE ELECTRONIC COMPONENTS OF THE SECONDARY
ELECTRICAL BOX
Figure 7.9.29-1
Follow the steps described in paragraph 7.9.28.
“Disassembling the secondary electrical box”.
With the electrical box resting on a bench:
To disassemble the IMS LPO BOARD
a :
1. Lift the board.
2. Disconnect the 3 connectors.
3. Disconnect the 4 plastic coupling elements.
4. Remove the card.
To disassemble the TRANSFORMER
b :
1. Disconnect the secondary cables from the
board connectors.
2. Unsolder the primary cables from the selector
switch.
3. Unscrew the holding screw a using an 8-
gauge wrench.
4. Remove the transformer.
To disassemble the 110/220 SELECTOR
SWITCH
c :
1. Unsolder the cables.
2. Unscrew the holding nut.
3. Remove the selector switch.
To disassemble the RECTIFIER
d :
1. Disconnect the cables.
2. Unscrew the holding nut.
3. Remove the rectifier.
To reassemble the ELECTRONIC
COMPONENTS OF THE SECONDARY
ELECTRICAL BOX, follow the above steps in
reverse order.