29
Electrical connections
The sensor is connected to both
DL
connections. The polarity of
DL
and
GND
on the controller is re
-
versible.
Alternatively
, the 12 V connection can be used for the power supply to relieve the load on
the DL bus. Otherwise, the sensor is supplied with power via the DL bus.
Any cable with a cross section of 0.75 mm² can be used for the data link (e.g. twin-strand) having a
max. length of 30 m. For longer cables, we recommend the use of shielded cable.
Technical data
Subject to technical modifications as well as typographical and printing errors. This manual is only
valid for devices with the corresponding firmware version. Our products are subject to constant tech
-
nical advancement and further development. We therefore reserve the right to make changes without
prior notice.
© 2022
Dimensions:
Width: 81.5 mm, height: 81.5 mm, depth: 18 mm
Protection class:
IP20
Maximum ambient temperature:
0°C – 40°C
Accuracy rel. humidity:
± 3% rH between 20 and 80% rH
DL-Bus load without 12V supply.:
20%
DL-Bus load with 12V supply.:
10%
Power consumption 12V supply.:
<0,1W
