97
(Continued)
To restore all the settings to the
factory defaults
When the following situations occur, reset the
memory:
•
There is no response when buttons are pressed.
•
You want to clear and reset the memory contents.
1 Press [SETUP].
2 Press [ ], [ ] repeatedly to select
“Initialization” and then press [OK].
3 Press [ ], [ ] to select “Yes” and then
press [OK].
•
A confirmation screen appears. Select “Yes” in
the following steps to restore all the settings to
defaults.
4 Press [ ], [ ] to select “Yes” and then
press [OK] again.
Note
•
If the setup menu cannot be entered, disconnect
the AC power supply cord and reconnect while
pressing and holding [
] after approx. 3 minutes
or later for restoring all the settings to the factory
defaults. (“Initialized” is displayed.)
General
The unit does not work.
Operations are not done properly.
•
One of the unit’s safety devices, etc. may have
been activated.
Press [
] on the unit to switch the unit to
standby.
•
If the unit does not switch to standby, press
[
] on the unit for at least 5 seconds. The
unit is forcibly switched to standby.
Alternatively, disconnect the AC power
supply cord, wait for at least 3 minutes, then
reconnect it.
Press [
] on the unit to switch on. (It may take
some time for this unit to be turned on.)
•
If the unit still cannot be operated, consult the
dealer.
•
The remote control may not work properly.
(
⇒
104)
