5
HOW TO INSTALL BATTERIES
●
Slide the lid of the remote control
unit following the indication and
remove it.
●
Insert two AAA alkaline batteries
of 1,5 V-DC.
Make sure the batteries point in
the direction marked in the
battery compartment.
●
The batteries last about six
months. Depending on how
much you use the remote control
unit.
Remove the batteries if you do not use the remote control unit
for more than one month.
Press the ACL button using a thin object, e.g. the point of a
pencil or a pen, after batteries replacement.
(This operation allows you to reset correctly all the programs.
The remote control unit is to be set up again).
Replace the batteries when the remote control unit lamp fails
to light, or when the air conditioner does not receive the remote
control unit signals.
●
The batteries of the remote control contain polluted substances
exhausted batteries must be disposed according to the laws
in force.
USING THE REMOTE CONTROL UNIT
ACL BUTTON
TEMPERATURE SENSOR SELECTOR (SENSOR)
●
Under normal conditions the room temperature is detected and
checked by the temperature sensor placed in the remote control
unit.
●
This button activates the temperature sensor placed in the
indoor unit. Press this button
using a thin object, e.g. the
point of a pencil or a pen. The
display will show the
mark . The air conditioner will
be set according to the intake
air temperature of the unit
(mean temperature of room air).
For normal use it is recommended the temperature sensor in
the remote control unit to be activated.
The remote control unit sends the
temperature signal to the air
conditioner regularly at three
minute intervals. If the signal from
the remote control unit stops for
more than ten minutes due to
some troubles, the air conditioner
will switch to the temperature
sensor which is built into the indoor unit and controls the
room temperature. In these cases, the temperature around the
remote control unit may differ from the temperature detected
in the air conditioner position.
NOTE
REMOTE CONTROL UNIT
DISPLAY
CAUTION
OPERATION WITH THE REMOTE CONTROL UNIT
Check that circuit breaker on the power panel is turned ON and
the operation selector of the indoor unit is in the ON position.
HOW TO USE THE REMOTE CONTROL UNIT
When using the remote control unit, always point the unit trasmitter
head directly at the air conditioner receiver.
(INDOOR UNIT)
RECEIVER
(TRANSMITTER HEAD)
REMOTE CONTROL
UNIT
EG
