28
MAINTENANCE
ATTENTION
- Switch off the unit and remove the
power supply before performing any
maintenance interventions.
- Do not spray or throw water on to the
unit. This could cause electric shocks or
damage the unit.
- Do not use hot water, thinners, abrasive
powder or strong solvents to clean the
unit.
In dusty rooms it ma y be necessary to
clean the air filters more frequently.
Attention after remo ving the fi lters, avoid
contact with the grilled heat exc hanger
(risk of cuts or abrasions).
CLEANING THE AIR FILTERS (EVERY THREE WEEKS)
CLEANING AND CARE
CLEANING THE FILTERS
- Clean the fi lters with a suction device.
- Make sure the fi
lters are in good
condition. If damaged, replace them.
- Replace the fi lters in their seats
- Close the front panel
- Make sure nothing is obstructing the
air intake or discharge of the indoor or
outdoor units.
- Make sure the unit is earthed correctly
- Make sure the fi lters are clean and if
damaged, replace them.
- P eriodically c heck that the br ackets
supporting the outdoor unit are integral.
CONTROLS BEFORE USE
(a)
(b)
(c)
- Remove the electric po wer supply after
use.
- Clean the filters, the indoor unit and the
outdoor unit.
MAINTENANCE AFTER USE
REMOVING THE FILTERS
- Lift the front panel of the indoor unit as
shown in figure (a).
- Remove the fi lters by lifting one of the
bottom corners as shown in figure (b).
- Remove the filters by pulling towards the
bottom as shown in figure (c).