GB
20
VALVE KIT - CODE 70600089 - CAW 6-8-10
• The valve kit includes:
- the valve body,
- 2 swivel couplings,
- 4 adapter couplings,
- actuator (with 230V “On / Off” heating element).
Assembly
A - Valve directly on the unit’s hydraulic connections
• Fit the 3/4” male - 1/2” female adapter couplings
on the unit’s female connectors, then screw the “2
part” portion of the swivel couplings onto the adapter
couplings. Use a stepped spanner or a hex wrench.
Put sealing compound or Teflon tape on the threads.
Important: Hold the unit’s couplings with a wrench
while tightening to avoid twisting the tubes inside
the unit.
• Fit the 3/4” female - 1/2” male adapter couplings
on the valve, then screw the “1 part” portion of the
swivel couplings onto the adapter couplings. Use
sealing compound or Teflon on the threads.
• Fit the valve on the unit at the level of the swivel
couplings. The valve is installed at the unit’s water
outlet.
•
Install the thermal actuator on the valve and
connect the cable in the electrical box as shown
in the electric wiring diagram.
• Mount the auxiliary tank (supplied with the unit) on the
side, below the valve. House the tank’s fitting in the
hole underneath the valve. Secure the tank with the
two screws provided.
B - Valve distant from the unit’s hydraulic
connections
• The valve can be installed on a pipe (not supplied)
enabling it to be offset from the unit’s hydraulic
connections.
In this case, place the valve along the unit, on the side
so that it is above the auxiliary tank.
Female
couplings of
the unit
Swivel coupling
(“2 parts” portion)
Auxiliary tank fitting
Screw
Screw
Swivel coupling
(“1 part” portion)
Valve
3/4” M-1/2” F
coupling
3/4” M - 1/2” F adapter
couplings
Valve
Water
outlet
Water
inlet
• Fit the valve on the unit at the level of the
swivel couplings. The valve is installed at the
unit’s water outlet.
• Install the thermal actuator on the valve and
connect the cable in the electrical box as shown
in the electric wiring diagram.
• Mount the auxiliary tank (supplied with the
unit) on the side, below the valve.
House the tank’s fitting in the hole underneath
the
valve.
Secure the tank with the two screws provided.
B -Valve distant from the unit’s hydraulic connections
• The valve can be installed on a pipe (not supplied) enabling it to be offset from the unit’s hydraulic
connections.
In this case, place the valve along the unit, on the side perpendicular to the electrical box, so that it is
above the auxiliary tank.
Auxiliary tank
fitting
Screw
Screw
Valve
Water
outlet
Water inlet
NOTE: for the model CAW5P4 use 1 kit code 70600088 and 1 kit code 70600089 (see below).
3742551181-I-TEC-CAW-GB.indd 20
3742551181-I-TEC-CAW-GB.indd 20
27/01/2015 13:55:37
27/01/2015 13:55:37
