9
EG
OPERATION
SELECTOR
CARE AND CLEANING
●
Cleaning and maintenance operations must be carried out by
specially trained personnel.
●
For safety, be sure to turn the air conditioner off and also to
disconnect the power before cleaning.
●
Never use solvents, or harsh chemicals when cleaning the indoor
unit. Do not wipe the plastic casing using very hot water.
●
Some metal edges and the vanes of heat exchanger are sharp
and may cause injury if handled improperly; be especially careful
when you clean these parts.
●
The internal coil and other components of the outdoor unit must
be cleaned every year. Consult your dealer or service centre.
WARNING
CAUTION
Do not have the flap pointed down during cooling
operation. Condensation may begin to form around the
air vent and drip down.
CAUTION
2. WHEN THE AIR CONDITIONER IS RUNNING
If you want to turn off the air conditioner push the button with a
pen until the OPERATION lamp is turned off.
Power failure during operation.
In the event of power failure, the unit will stop. When the power
is resumed, the unit will restart automatically after 3 minutes.
NOTE
If you have lost the remote control unit or it has troubles, follow
the steps below.
1. WHEN THE AIR CONDITIONER IS STOPPED
If you want to turn on the air conditioner push the button to select
the desired mode:
•
COOL or HEAT for heat pump models
•
COOL for cooling only models
OPERATION WITHOUT THE REMOTE
CONTROL UNIT
1.
Remove the screw on each side out of the latch using a
screwdriver.
2.
Press on the two latches of the air intake grille with your thumbs
in the direction of the arrow to open the grille.
3.
Open the air intake grille downward.
4.
Remove the air filter from the air intake grille.
5.
Use a vacuum cleaner to remove light dust. If there is sticky
dust on the filter, wash the filter in lukewarm, soapy water, rinse
it in clean water, and dry it.
3.
Insert the filter correctly again inside the grille, close the grille
letting the latches slide toward the outside and fix again the
latch with the screw on both sides.
AIR FILTER
The air filter should be cleaned at least once every six months or
more frequently; it depends on the real operation conditions.
HOW TO REMOVE THE FILTER
L A T C H
S C R E W
AIR INTAKE GRILLE
AIR FILTER
HOW TO REMOVE THE AIR INTAKE GRILLE
G R I L L E
STRING
1.
Detach the safety string from the frame (remember to attach it
again after cleaning or maintenance).
2.
Open the air intake grille, hold it on and pull it toward you to
detach the two guides.
3.
Clean the grille gently using a soft sponge, or the like. Then
dry it with care.
Neutral detergent may be used to remove stubborn dirt. Then
rinse thoroughly with water and dry it.
The air conditioner will start in automatic fan speed and flap
sweep operation. The temperature setting is 22°C for cooling
mode and 28°C for heating mode.
NOTE
Содержание CAF124R5TA Series
Страница 47: ......