M6x40mm, x4
Washers, x4
ASSEMBLY INSTRUCTIONS FOR CHAIR MODEL
RTA-8070
PARTS LIST
ATTENTION:
Before you begin the assembly,
make sure that all parts are included in good
condition.
ATTENTION:
⚠
Follow the instructions step by step.
⚠
To avoid misalignments, leave the screws loose and do not tighten them until all are in their respective places.
⚠
Do not overtighten or force the screws as they could break, strip, or damage the threads of the holes.
⚠
Using the wrong size of screws on a part could result in damage to the screw or the part.
E
F
C
B
A
J
A
Backrest, x1
B
Seat, x1
D
Mechanism,
x1
E
Hydraulic
Gas Lift, x1
F
C
Star Base, x1
H
Caster, x5
I
Hole Covers
J
M6x20mm, x4
L
K
Insert the casters (F) into the legs of
the base (C) using pressure, then
place the gas lift (E) in the middle of the
base as shown.
Proceed to tighten the screws (H) and
then cover the top holes with the long
covers (K) and the bottom holes with the
short ones.
(Backrest viewed
from behind)
X1 Right
X1 Left
(Mechanism)
(Armrest to Backrest)
Allen Wrench, x1
Tighten well all the screws before you
sit on the chair for the first time.
NOTE: When you are seated
on the chair, not looking at it.
G
Armrest
M6x25mm, x4
(Armrests to Seat)
I
X2 Long X2 Short
Assemble the armrests (G) to the
backrest (A) on their respective sides
using screws (H), but leave the screws very
loose to allow flexibility on the next step.
G (RIGHT)
G (LEFT)
H
Assemble the armrests (G) to the
seat (B) using screws and washers
(J) as shown and tighten them.
G (RIGHT)
G (LEFT)
Using screws (I), assemble the
mechanism (D) with its handle facing
to your left and its knob towards the front of
the chair as shown.
K (LONG)
K (SHORT)
Place the seat over the base making
sure that the tip of the gas lift enters
in the hole of the mechanism.
(Armrests)
(backrest viewed
from behind)
(FRONT OF CHAIR)
