11
Model: TX-203,TX-204,TX-228; Article No. 5021,5023,5040; 10/2022
Mounting
Observe the following instructions for the corresponding installation.
General hints
⚫
Before you start mounting, check the solar module, the inverter and all cables for
visual damage.
⚫
Do not stand on the module or the module frame. To prevent grease stains on the
module, avoid contact with your hands on the glass surface and ideally wear work
gloves.
⚫
Place the solar module face down on a clean, flat, soft surface.
⚫
Write down the model and serial number of the components [inverter, solar
module(s)] and keep the numbers. In the event of a defect, we will need the numbers
for unique identification.
Balcony
⚫
The solar module is only suitable for installation up to a height of 4m (upper edge of
the module), provided that there is also no public traffic below the module.
*The balcony bracket is available as an accessory:
- Balcony bracket TX-227 for TX-212
- Balcony bracket TX-230 for TX-220 & TX-228
Flat roof (bitumen roof)
⚫
The statics of the roof for the photovoltaic system must be checked by the customer.
The photovoltaic system can be installed up to a roof height of 9m, a sea level of max.
350 m and a roof pitch of 45°.
⚫
We recommend a distance of 1.25 m to fire walls of adjacent buildings (e.g. row
houses). For more detailed requirements for your federal state, please refer to your
state building code (LBO).
⚫
Make sure that national and site-specific building regulations, occupational safety
and accident prevention regulations, standards and environmental protection
regulations are observed.
Weight the module mount evenly
⚫
The solar module (up to 19kg) should be positioned at ground level or centered on
a flat roof.
⚫
Suitable is a bracket for mounting on bitumen, concrete, in the garden on the lawn
or terrace.
⚫
The weighting is calculated according to the terrain IV (urban area), where at least
15% of the area is covered with buildings, the average height of which exceeds 15m,
and may differ for other heights or terrain structures.
⚫
In case of installation on a flat roof, the top edge of the building should be lower
than 15m and the photovoltaic system should be at least 1.25m away from the
neighbor's roof surface. The maximum slope of the ground may be 5°.
⚫
One concrete slab should weigh 9kg.
⚫
Check whether the statics of the installation site are suitable for the photovoltaic
