Street:5C Wendy Ct. Greensboro, NC 27409▪Mailing: PO Box 18542,
Greensboro, NC 27419▪P:336-856-2919▪F:336-217-8838
Email:[email protected]▪Web:www.AdvancedGourmet.com
Distributed By:
P a g e |
5
2)
GENERAL SAFETY
2i: GENERAL SAFETY STANDARDS
The Chiller in question is manufactured conforming with the European Directives relevant to low tension
73/23-
93/68/EEC,
and electromagnetic compatibility 89
/336/EEC;
EN60335- 1, EN60335-2-24, EN55014, EN61000-
3-2, EN61000-3-3, EN55104.
2ii: LOCATION REQUIREMENTS
It is necessary that electrical supply to the freezer be provided as specified on the data plate of your Techfrost
freezer. Each freezer comes with electrical cord and power connector as required.
The chiller and its control board should only be operated by adults.
Installation and any other operation (including a possible extension of the power cable) must be carried
out by
authorized personnel
only.
Maintenance and service have to be carried out by qualified technicians. Only factory replacement
parts should be used for repairs.
Do not attempt to modify the chiller yourself; the operation could be dangerous.
In order to avoid the risk of over-heating of the compressor and consequent damage, it is crucial to
allow sufficient air circulation around the machine.
The chiller should be placed so that there remains sufficient space for air circulation in the back (at
least 10 cm or approximately 4in.).
While installing or transporting the unit, take care in ensuring that the cord is not crimped or kinked.
Before any cleaning or installing operation, remember to switch the machine off and disconnect the
plug. Make sure you do not pull the cord.
The deep-freezing system, placed on the back and inside the machine, contains a refrigerant solution.
Do not use sharp objects in the vicinity of the evaporator, cooling plate, or near the pipe coils (located
on the back and inside the chiller). The accidental perforation of the system could cause damage to the
unit.
Wait for at least 30 minutes before connecting the plug to the power point after sitting freezer in place.
If the chiller has been transported in the horizontal position, be sure to keep it vertical for at least four
hours. This allows the oil contained in the compressor to be transferred back to its original location.
WARNING! Do not keep explosive gases and liquids or glass bottles in the machine. Doing so may
result in damages to persons or things.
When the
“DEEP-FREEZING”
process has concluded, dry gloves or cloths should be used to remove
containers from the machine.
Do not open the machine door while executing its working cycle. Doing so may prevent cycle
completion.
The constructor is not liable for damages arising from improper use or installation, connection to non-
authorized equipment, use of non-original fittings, or tampering by non-authorized personnel.
CAUTION: The Blast Chiller/Blast Freezer must be connected to an electrical supply source that matches
the data plate on the machine. Make sure it is level and always use qualified personnel to install, repair
and service your Chiller.
3)
INSTALLATION
3i: INTRODUCTION
This manual aims to provide the user with all the necessary information to correctly use and maintain the chiller.
Before use, carefully read all the instructions given in this manual. The manufacturer shall decline all
responsibility for operations and use which disregard the instructions herein.
