5. Programming Procedure
5.3 Editing a Defined Program
To edit a defined program, proceed as described in the Defining a New Program
section and edit the parameters as required. If the program is locked it can not be
edited with the onboard software and the following error message is displayed:
Program locked
yes
5.3.1
Changing the Type of Defined Process Step
To change the type for a defined process step, use the
-
and
+
keys to scroll to
the required process step number that is to be altered.
When the required type of process step is displayed, press
other
to scroll the
type of process steps across the display.
When the required type of process step is displayed, press
yes
to confirm the
selection.
The instrument enters the programming procedure for the selected process step.
Note:
If an existing process step has been changed to End, all previously
defined steps after this step in this cycle have now been deleted.
5.3.2
End Programming Procedure
To end the programming / editing procedure when all the required parameters
have been altered, use the
-
and
+
keys to scroll to the End program step.
C:X P:Y END
- + other yes
Where C:X is the cycle number and P:Y is the process step number for this cycle.
Press
yes
to confirm the selection of the End process step and the programmed
parameters for the End step are displayed.
When the parameters for the End step have been confirmed, the instrument
returns to the standby mode and the following message is displayed:
Run XX:yyyyyyy
- + other yes
The instrument is now ready to use the program, which has been edited.
5-6
Instructions for Use for Columbus Washer No. I 109 006 Rev No. 2.2
May 2003
