Refer to Figure 91 in the Owners Manual to install
the radio antenna on the truck.
Install the radio
system batteries, 8 in the bottom of the transmitter and
4 into the back of the model as shown. Use only quality
alkaline or rechargeable Ni-Cad AA-size cells.
Radio Batteries
Ignitor Battery
Remove the cover from the glow plug ignitor.
Install a “C” size alkaline battery with the “+” end
of the battery as shown in the figure above.
Throttle
Brake
Throttle
Brake
Steering
Steering
Operations Check
Always turn the transmitter “on” first and check the display screen
for adequate voltage. Turn on the model and check both the
throttle and steering for proper operation and battery power.
“C”
Size
+ Pos
- Neg
Slide back the battery access panel opposite the hand strap and
remove the cover. Remove hex starter shaft from the back side
of the cover (fig 2a.) and press the o-ringed end into the drive
cup. Slide a 7.2 volt 6 cell “stick pack” into the Spin-Start and
plug it in. Note that the plug is made such that it can be plugged
in one way. Carefully tuck the plug wires under the battery ac-
cess panel and slide shut.
Spin Start Battery Install
Fueling
Lift the lid of the fuel tank, place the tube of the
fuel bottle into the opening and carefully fill the
tank. Do not allow fuel to overflow as spilled fuel
can cause radio damage.
Getting Started
Getting Started
Before you start running your XXX-NT Sport Ready-to-Run, read your engine break-in and operating
instructions. If you run your XXX-NT Sport without following proper break-in procedure, you may dam-
age or fail to get maximum performance from your engine, and void warranty.
NOTE:
1
2
2A
3
4
5
