Team Losi Losi Mega Baja, Руководство по эксплуатации

Страница: 8 / 24

Page
Replacing the 2-Speed Gears
Be sure to replace the
one-way bearing in the
same direction as removed.
Use a 3/32” wrench (provided) to remove the retaining screw (turn counterclockwise) while firmly hold-
ing the flywheel with a pair of pliers. Remove the screw, washers and clutch bell, being careful not to
lose any shims that may be used. Remove the ball bearings and brush any loose dirt away from the
bearing faces. Put only ONE drop of oil on the inside face (the side facing away from the clutch shoes)
near the inner race of the bearing. Install the bearings into the new clutch bell. Before replacing the
clutch bell, wipe out the inside with motor spray, lacquer thinner, or a similar cleaner (do not use fuel or
oil-based solvents). Replace the clutch bell and secure with the retaining screw in the same manner
used to remove it. Note: do not over-tighten the screw, as it is not necessary.
Replacing the Clutch Bell