Team Blacksheep TBS UNIFY EVO 5G8, Руководство пользователя

Страница: 9 / 18

Installation / Mounting
When installing the Unify EVO, please ensure adequate airflow during flight. Up to power levels of 200mW,
no airflow is less critical. With higher power setting airflow is required to maintain the set power level.
In case there is no or not enough airflow to maintain the temperature limit, the Unify EVO will slowly
reduce output power to ensure proper function without any overheating. The reduction in output power is
slow and gradual so there is no immediate range issue. As it regulates back the output power, red LED
starts to blink.
Pinout
Control by Flight Controllers (Smartaudio)
Using any Smart Audio V2.1 compatible flight controller simply connect the Smart Audio data pin to a free
and supported port on your FC (see pinout below).
For Betaflight users, you can then configure the connected port in Betaflight configurator to Smart Audio
V2.1 protocol. Ideally you make sure to get a Betaflight firmware which supports the new SA2.1 (Betaflight
>=V3.5.6) rather than the older SA2.0. This way you get access to the new power levels of SA2.1.
If you use BF 4.xx or later, you need to add the VTX table. You can download the VTX tables for all TBS
UNIFY VTXs here .
9