OpenTX mixer bypass (Gimbal destination)
Exclusively on the TBS radios, you can bypass all OpenTX mixer settings to save an additional millisecond.
When activated, all mixer settings like endpoints, channel order (for the first 4 channels), stick order, trims,
etc are ignored.
With an active bypass, the channel order for the first four channels is AETR - Aileron, Elevator, Throttle,
Rudder. Use this sequence when configuring your flight controller. You can activate it under
CROSSFIRE TX/ Radio Settings/ Gimbal Dst.
●
FreedomTX: FreedomTX mixer active, bypass deactivated
●
XF Mode 1-4: Bypass active. Setup the number according to your
(Mode 2 for most
users)
Programming examples
The required sensors only show up once they were found by the sensor search on the telemetry page.
LQ warning (audio)
FreedomTX will warn you based on the LQ sensor. There is no extra setup required. The warning level can
be set up in the
Model settings/ Telemetry
46
