W
IND
T
URBINE
S
TAND -
B
UILD
Page 1
Materials Required:
Part
Quantity
¼” Wing Nut
1
T-Plate
2
¼” Lock Nut
4
¼” 1 ¼” Screw
Stand Base
Stand Upright
Tools Required:
Straight Screwdriver
7/16” Wrench or Pliers
Страница 1: ...WIND TURBINE STAND BUILD Page 1 Materials Required Part Quantity Wing Nut 1 T Plate 2 Lock Nut 4 1 Screw 4 Stand Base 1 Stand Upright 1 Tools Required Straight Screwdriver 7 16 Wrench or Pliers ...
Страница 2: ... Page 2 Step 1 Attach the two T plates to the base of the stand using 2 screws and locking nuts Use these holes in the base Your wind stand base may not have the center hole Upright Lock Nuts and Screws Wing Nut and Screw Base ...
Страница 3: ...tep 2 Attach the upright to the T plates using 2 screws Place a lock nut on the bottom screw and a wing nut on the top screw Tighten the lock nuts and wing nut Your turbine stand is done Lock Nuts and Screws Wing Nut and Screw T Plates ...
Страница 4: ...can now attach your geared or direct drive turbines Folding the stand down The upright on your stand can be folded down for storage a Unscrew the wing nut b Remove the loose screw the screw the wing nut attached to c Fold the upright down ...
