6
TEAC UR-Stream
Setup procedure
1. Using a category 5E or higher LAN cable (
1
) connect the
UR-Stream to a switching hub that supports PoE Plus power
supply.
NOTE
To connect to a switching hub that does not support PoE Plus
power supply, use a dedicated PS-P1220E AC adapter (sold
separately) to supply power.
Use the AC adapter (TASCAM PS-P1220E) to connect a power
supply to the unit as shown below.
DC plug
Power outlet
TASCAM PS-P1220E (sold separately)
2. Connect HDMI devices to the HDMI IN/OUT connectors (
2
).
To encode:
Connect a camera or other video source to the HDMI IN
connector.
When the video source becomes active, the INPUT
indicator on the front of the unit lights.
To decode:
Connect a video monitor or TV to the HDMI OUT
connector.
3. Connect the included USB flash drive to a computer
connected to the network and open the “Setup” folder.
4. Select the file for the operating system being used and
install TASCAM DISCOVERY.
5. Launch TASCAM DISCOVERY.
6. Click “Open” for the UR-Stream that you want to log into
and launch the “Streaming Dashboard”.
7. Click the tab area screen selection buttons to open the
encoder or decoder settings screen.
To encode:
o
Click “Encoder Control” to open the Encoder Control
screen.
o
Click the Output Settings
button on the
Encoder Control screen to open the encoder output
screen.
o
Select the tab for the desired streaming type.
To decode:
o
Click “Decoder Control” to open the Decoder Control
screen.
o
Click the Stream Settings
button on the
Decoder Control screen to open the Decoder Stream
Settings screen.
o
Select the tab for the desired streaming type.
Specifications
