Teac TD-9000T, Инструкция по эксплуатации

Страница: 9 / 20

9
Communication from a scanner to a TD-9000T
Output data (scanner to TD-9000T)
Bit 15 14 13 12 11 10 9 8
Setting
Clear peak/
bottom
Prevent
touchscreen
operation
Enable/
disable judg-
ment output
Force back-
light lighting
Switch zone Reserved
Clear results
(reset mea-
surement
results)
Start/stop
measurement
Status
Bit 7 6 5 4 3 2 1 0
Setting Digital zero
Zero balance
displacement
Switch sensor Switch work
Status MSB LSB MSB LSB
2. Communication functions
Clear peak/bottom
Clear peak and bottom load values.
Prevent touchscreen operation
Disable touchscreen operation while this is ON.
Enable/disable judgment output
Disable all judgment output while this is ON.
Force backlight lighting
Enable the backlight while this is ON.
Switch zone
This is enabled when ZONE SWITCHING is set to EXT.
INPUT. While ON, it becomes zone. Switching is limited to
zones that have zone judgment enabled.
Clear results (reset measurement results)
Judgment results are cleared at the moment this becomes
ON.
All judgment output is turned OFF, and continuous judg-
ment (CONTINUE) starts.
Start/stop measurement
When “MEASURE. START. COND.” or “MEASURE. STOP.COND.”
is set to “EXT. SIGNAL”on the WORK settings screen, this
controls starting and stopping measurement.
Select the control method with EXT. START/STOP.
When set to “EDGE”, measurement will start or stop when it
switches from OFF to ON.
When set to “LEVEL”, measurement will start when it
switches to ON and stop when it switches to OFF.
Digital Zero
Digital zero is executed at the moment this becomes ON.
Zero balance displacement
The displacement sensor is zero-balanced at the moment
this becomes ON.
Switch sensor
Switch the sensor memory to the specified number.
ATTENTION!
To enable sensor switching, set MEMORY CONTROL to
“ALLOW” (page 6).
Switch work
Use to switch to the specified work number.
WORK SWITCHING 1 is the LSB and WORK SWITCHING 8 is
the MSB.
ATTENTION!
Make the following settings to enable work switching.
o
CONTROL INPUT on the FIELD NETWORK settings
screen: COMM.
o
MEMORY CONTROL on the FIELD NETWORK settings
screen: ALLOW
o
WORK SWITCHING on the WORK settings screen:
MANUALLY