Teac TD-9000T, Инструкция по эксплуатации

Страница: 10 / 20

10
2-4. Message communication (setting commands)
Parameters used by all commands
Read: Get Attribute Single (0Eh)
Write: Set Attribute Single (10h)
Class (Hex): 0A2h
Attribute: 05h
By designating each command number in an instance when communicating messages, the desired parameters can be read and
written.
NOTE
If values other than parameters are set, they will be ignored.
System
Content Command Command No. Byte Parameter Note
System
Device name 5010 16 “TD-9000T “ ASCII
Firmware version 5020 6 “1.00 “ ASCII
Backlight setting (LCD
BRIGHTNESS)
5301 1 0 to 3
Backlight time 5302 1 0 to 255
Language 5303 1
0: Japanese, 1: English, 2: Chinese,
3: Korean
Home Screen 5304 1 0: value display, 1: waveform display
OK counter 5410 4 100: Reset
64 in hexadecimal
display
NG counter 5411 4 100: Reset
64 in hexadecimal
display
Device number 5500 4
Beep 5501 1
0: OFF
1: KEY
2: KEY + JUDGE
External measurement
signal mode (EXT. START/
STOP)
5502 1 0: Edge, 1: Level
Date & time setting
Format 5503 1
0: YYYY-MM-DD
1: DD-MM-YYYY
2: MM-DD-YYYY
Date & time setting 5506 6 YYMMDDHHMMSS(BCD)
For example,
14:20:30 on May
20, 2021 shown as
210520142030
Locking
Lock calibration values
(CALIBRATION LOCK)
5201 1 0: Unlock, 1: Lock
Lock work (WORK LOCK) 5202 1 0: Unlock, 1: Lock
Lock all (ALL LOCK) 5203 1 0: Unlock, 1: Lock
Lock touchscreen 5204 1 0: Unlock, 1: Lock
Internal memory
Save results (SAVING) 5400 1
0: NO
1: AUTO SAVE
2: SAVE ON ERROR
Overwrite (OVERWRITING) 5401 1 0: Forbid, 1: Allow
Delete all 5402 4 100: Execute
2. Communication functions