Teac Tascam MA-BT240, Руководство пользователя

Страница: 18 / 124

18
TASCAM MA-BT240
Basic operation
Operation 1. Turning the unit on
1.
Confirm that the power switches are off on all devices
connected to this unit.
2.
Confirm that the MASTER knob is set to 0 (turned
completely counterclockwise).
3.
Connect the included power cord to the AC IN connector
and insert the power plug in an outlet.
4.
Turn on the power to the connected devices before
turning this unit on.
ATTENTION
o
The output from the LINE OUT jacks on the rear panel are
affected by the settings of the MIC/LINE, LINE 1 and LINE 2
knobs, but not by the MASTER knob.
o
When adjusting the volume, minimize the settings of the
MIC/LINE, LINE 1 and LINE 2 knobs beforehand.
NOTE
When turning off the power, turn off this unit before turning
off connected devices.
Operation 2. Adjusting the volume (mix)
1.
Adjust the MASTER knob so that the speaker volume
is low.
Adjust this again as necessary while conducting the
following procedures to prevent the volume from
becoming too loud.
2.
Turn the volume knobs for each input to adjust their
volumes.
Input audio signals through the inputs being adjusted,
and adjust them so that their SIGNAL indicators light
but their PEAK indicators do not light.
NOTE
To adjust the Bluetooth volume, adjust it on the Bluetooth
device.
TIP
Adjusting the balance is easier if the volume of the
main channel is adjusted first, followed by the volumes
of the remaining channels.
3.
Adjust the MASTER knob to set the desired volume.
Indicator Status
POWER
Lit green Power is on
Blinking
orange
Protection circuit is active
Lit Connected
Blinking Pairing or waiting to connect
MIC/LINE
SIGNAL lit Less than 40 dB below maximum input level
PEAK lit Less than 3 dB below maximum input level
LINE 1
LINE 2
SIGNAL lit Less than 40 dB below maximum input level
PEAK lit Less than 3 dB below maximum input level
MASTER
SIG lit Less than 46 dB below maximum output level
CLIP lit Over maximum output