ENGLISH
Troubleshooting
_ 11 _
Problem
Probable cause(s)
Suggested remedy
No power when power button is pressed.
Power plug not inserted securely.
Plug in securely.
No playback when disc is loaded.
Disc loaded with label side down.
Load with label side up.
Disc dirty.
Clean disc surface.
No audio output (or too low level output).
Connection to stereo system is incorrect.
Check connections.
Misoperation of amplifier.
Check amplifier's control/switch setting.
A single track can only be played.
1/ALL button engaged.
Press button to disengage it.
No program playback.
Program button not pressed.
Press button to display "PROGRAM".
Play button not pressed.
Press button.
Mistracking (sound jumping).
Player receiving vibration or shock.
Change the installation position of player.
Disc dirty.
Clean disc surface.
Hum.
Pin-cord plug not connected securely.
Re-connect plug securely.
Noise in tuner.
Player too near tuner.
Keep a reasonable distance between
them or switch off player's power.
Remote control unit operation is impossible.
REMOTE CONTROL SELECTOR switch is
Set switch to correct position.
not set correctly.
Refer to page 5.
Batteries not inserted in remote control unit.
Insert batteries.
No programming is possible. Numeric
The remote control is set to a mode other
Select CD on the remote control.
button entry is not accepted.
than CD.
"Err" indication appears on the display
Inserted 8 cm disc into disc tray 2-7.
8 cm discs can be used only in Tray No. 1.
and the disc tray is opened.
Load a 12 cm disc in the disc tray and
press the open/close button to close.
Before calling for service, check through the chart below for probable causes of the problems you experience while using this unit.
