TE Ocean 2.0, Инструкция

Страница: 23 / 30

408-35043
Rev D
23 of 30
11. Adjust the strip hold-down plate (if present) so that it is perpendicular to the terminal strip. Position it so
that it does not interfere with the slug blade tooling on the ram (Figure 5).
12. Tighten the remaining screws on the strip guide.
13. Verify that the terminal strip is centered over the anvil and in line with the radius nest on top of the
anvil.
14. Reinstall the drag plate, drag springs, and securing nuts.
15. Adjust the drag.
6. REPLACEMENT AND REPAIR
These procedures cover the applicator parts that most often need replacement or repair due to wear. Stock and
control a complete inventory to prevent lost time when replacement of parts is necessary. Order replacement
parts through your TE representative. You can also order parts by any of the following methods:

Go to TE.com and click the Shop TE link at the top of the page.

Call 800-522-6752.

Write to:
CUSTOMER SERVICE (038-035)
TE CONNECTIVITY CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For customer repair services, call 800-522-6752.
Disconnect electrical power when performing maintenance or repair on this equipment.
6.1. Before replacing or repairing
1. Turn off the machine.
2. Disconnect the power cord.
3. Ensure that the machine ram is in the raised position
4. Remove the applicator from the machine.
5. For identification of parts, refer to the exploded view drawing on the applicator log and the parts list
packaged with the applicator.
6. Wipe the parts with a clean, dry cloth as you remove them from the applicator.
7. Before putting parts back into the applicator, wipe the mating surfaces with your fingers to ensure that
all lint and other foreign matter have been removed.
6.2. Replacing the anvil
1. Verify that the part number of the new anvil matches the number on the applicator parts list.
2. From the bottom of the base plate, remove the screw that secures the anvil to the base plate.
3. Remove the anvil from the groove in the top of the base plate.
4. Install the new anvil.
5. Reinstall the screw that secures the anvil to the base plate.