409-32043
Rev. D
8
of 11
OPERATION
Installing and removing the battery
NOTE
introduces new requirements from September 2008 on removability of batteries from waste equipment in
EU member states. To comply with the directive, this device is designed to allow the rechargeable battery pack to be easily
removed by the end-user when it needs to be replaced.
To install the battery, slide the battery into the bottom of the crimping tool until it can go no farther. An audible
click from the battery lock indicates that the battery has been properly installed.
To remove the battery, disengage the battery lock by applying pressure on the lock toward the bottom of the
crimping tool and slide the battery away from the tool.
DANGER
Always dispose of the old battery in an environmentally-responsible way, in accordance with local waste regulations. Where
possible, recycle the battery. Contact your local authority for details of battery recycling locations in your area.
Installing and removing the die assemblies
DANGER
To avoid personal injury, exercise extreme caution when handling the crimping tool. Remove the battery before installing or
removing the die assembly.
CAUTION
Do not operate the tool without the die assembly installed. Damage to the crimping head can result.
The following instructions are specific to the use of TE SDE die assemblies. Make sure to use only TE SDE die
assemblies.
