408-35241
Rev
A
4
of 4
6.
MAINTENANCE AND INSPECTION
Each die assembly is inspected before shipment. When it arrives at your facility, inspect it immediately to
ensure that it was not damaged during shipping.
6.1.
Daily maintenance
Make each operator aware of (and responsible for) the following daily maintenance requirements:
Remove dust, moisture, and other contaminants with a clean, soft brush or soft, lint-free cloth.
Do not
use objects that could damage the dies.
When the dies are not in use, store them in a clean, dry area.
6.2.
Periodic inspection
Regular inspections should be performed by quality control personnel. A record of scheduled inspections
should remain with the dies or be supplied to personnel responsible for the dies. Perform at least one
inspection per month. Base your inspection frequency on the amount of use, ambient working conditions,
operator training and skill, and established company standards. Perform the inspection as follows:
Remove all contaminants with a clean, soft brush or soft, lint-free cloth.
Do not
use objects that could
damage the dies.
Inspect the crimp area for flattened, chipped, cracked, worn, or broken areas. If damage or abnormal
wear is evident, replace the dies. Refer to Section 7, REPLACEMENT AND REPAIR.
7.
REPLACEMENT AND REPAIR
If the dies are damaged or worn excessively, they must be replaced. Order replacement dies through your TE
representative. You can also order parts by any of the following methods:
Go to
Shop TE
link at the top of the page.
Call 800-522-6752.
Write to:
CUSTOMER SERVICE (038-035)
TE CONNECTIVITY CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For customer repair services, call 800-522-6752.
8.
REVISION SUMMARY
Revisions to this instruction sheet include:
Initial release